RME AEB8-O: Analog Expansion Board for the DIGI96® series 8 analog outputs with 24 bit DA-converters The AEB8-O offers 8 outputs with 4 stereo TRS jacks. Usual insert cable can be used to split the connectors from stereo jack to mono jacks. It is also possible to drive up to 4 stereo headphones directly. Level adjustment +4 dBu/-10 dBV, 106 dBA SNR and highest suppression of PC-noise guarantee perfect sound quality.
Technical Specifications and Features
Output AEB8-O 4 x 1/4" TRS jack, unbalanced
Dynamic ratio 103 dB (RMS unweighted), 106 dBA
THD+N -95 dB (0.0017 %)
Frequency response -0.1 dB: 10 Hz - 21 kHz
Output level for 0 dBFS @ +4 dBu: +12 dBu
Output level for 0 dBFS @ -10 dBV: +2 dBV
Crosstalk > 110 dB
Supported sample rates 32 kHz - 48 kHz
Output impedance 75 Ohm
Power supply uses 3.5" floppy connector, 12/5 V DC, 190 mA
AEB needs no slot on the motherboard
Standard bracket, board dimensions AEB4: 85 x 95 mm, AEB8: 120 x 95 mm
1 internal cable 2-pin, 1 power adapter cable 5 1/4" to 2 x 3.5" included
Notes on Compatibility
AEBs use the internal ADAT interface of the DIGI cards. Therefore they do not work with the DIGI96 (which did not support ADAT). To operate the AEB4-I and AEB8-I the used DIGIs must have the connectors ST6/7 on board (for the Word Clock Module). These were not present on the very first cards of the DIGI96 series (1998 to beginning of 1999).
One AEBx-I and one AEBx-O can be connected and operated simultaneously, in all possible combinations.
An operation with the Hammerfall or Hammerfall Light requires board revision 1.5 or higher, because the internal connectors ADAT1Out, ADAT2Out and ST7 were not implemented in earlier versions.
One AEBx-I and two AEBx-O can be connected and operated simultaneously, in all possible combinations.
RME Audio RME AEB8-O
Have a question about the RME Audio RME AEB8-O?
Call us toll free at 1-800-878-8882.