"The Finger" uses a single medium diaphragm transducer to provide detailed sound with smooth transparent highs, optimal presence and natural low-end response with a unidirectional polar pattern. "The Finger" has a unique body design with an integrated tapered reflector which reduces resonances, removes reflections and optimizes the microphone’s cardioid polar pattern. Integrated damping of the transducer reduces stand rumble, outside infrasonic interference and mechanical shocks.
The optional and unique FRR Reflection Ring is a reflector disc (shown below) which can be positioned at the head or anywhere along the body of the microphone to alter the polar pattern, frequency response and sensitivity. Positioning the FRR at the end point of "The Finger’s" reflector alters low-frequency response and adds proximity effect. The FRR can also be used to separate the front and rear sides of the capsule and to reduce reflections and reverberation from reaching the capsule. Positioning the FRR on the capsule head’s top produces a polar pattern closer to a half-sphere pattern with less coloration at different angles, less proximity effect and adds sensitivity to all except high frequencies. It is even possible to use 2 FRRs, positioning one on the top of the head and one elsewhere on the body for effect.
"The Finger" is available in 2 styles. "The Black Finger" has polished nickel-plated hardware and a matte black body. "The Gold Finger" has polished gold-plated hardware and a matte black body. Matched stereo pairs can be special ordered.
- Diaphragm’s Diameter (inch/mm): .5"/14 mm - Polar Pattern: Cardioid - Output Impedance: 50 ohms - Rated Impedance: 1000 ohms - Suggested Load Impedance: > 250 ohms - Frequency Range: 20 Hz to 20 kHz - Sensitivity @ 1000 Hz: 12 mV/PA - S/N Ratio CCIR: 468-3 Weighted 71 dB - S/N Ratio DIN/IEC: 651 A-weighted 82 dB-A - Equivalent Noise Level: 12 dB-A - Maximum SPL (<0.5% @ 1000 Hz): 140 dB - Preamplifier’s Dynamic Range: 128 db - Electronics Type: SS - Powering +48V Phantom or PSU: PH - Polarity pin: 2 in phase - Output Transformer: N - Output Connector: XLR-3M - Dimensions (inch/mm): 8.1 x .94"/207 x 204 mm - Weight (lbs/grams): 7 oz/200 g - Included Accessories: Microphone comes in a solid wooden box, with a stand holder and a manual
Violet Design Gold Finger
Have a question about the Violet Design Gold Finger?
Call us toll free at 1-800-878-8882.