The new Klark Teknik DN100 Direct Injection Box is the natural successor to the long-established LBB100. A ground-up redesign provides an extended dynamic range, lower noise floor and all the world-class audio performance you'd expect from Klark Teknik. DN100 is also designed to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing, which is replaceable and available as a spare part. It is also fitted with a Kensington security slot in one of the end panels to allow the unit to be made secure using a Kensington MicroSaver security cable.
Attention to detail – it's what makes a good unit into a great one.
Input Type active electronic, balanced or unbalanced Impedance 1M ohms nominal, balanced or unbalanced (jack connectors) 20K ohms (XLR input only) Connectors 2 quarter inch jacks and 3-pin XLR linked in parallel Max. Level 30dBu Attenuator 30dB, switchable
Output Type Transformer Isolated, balanced Impedance 300 ohms Connector 3 pin XLR Max. Level 10dBu with load >2k ohms Min. load 600 ohms
Performance Noise -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor Frequency response +0.5/-1dB 20Hz to 20kHz Distortion (THD+N) <0.01% @ 1kHz, +4dBu output
Power Requirement Voltage +48V Phantom * Current consumption <10mA Weight <1kg Dimensions Length 142mm (5.6 inch) Width 106mm (4.2 inch) Height 60mm (2.35 inch)
* The DN100 has been designed to allow use at phantom voltages less than +48V. The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V Phantom power.
Klark Teknik DN100
Have a question about the Klark Teknik DN100?
Call us toll free at 1-800-878-8882.